Durkeesox fabric duct dispersion system

Design

There is no big difference of the design procedures for traditional Durkeesox® system and IRRTM system.Only 4 common steps: system layout design; dimension selection; permeability selection; air supply mold selection.

 

Model Identification

1.IRR/N10/OΦ508x20/G(IRR/N10/O20"x65.6'/G)

Internal Retention Ring System, N general fabric with permeability of 1cfm/ft2 (18m3/m2/h), round, 508mm(20")in diameter, 20m(65.6ft) long, orifice air dispersion mode, single row suspension.

 

Installation

The installation of IRRTM system is much easier than any other duct system, due to adopting the single row suspension system, which consists of 2 styles: cable suspension system and aluminum track suspension system.

 

1.Cable Suspension System

Due to the cable suspension system is easy to install with low cost, it’s the most popular type in application.

 

2.AL-H Track Suspension System

Pulling cable is requested at the end of each straight duct to ensure smoothness and flatness of duct surface.

More information:http://www.durkeesox.com/en